Repair Kit

Repair   Glue-Silicone  

• Clean the damaged area to ensure that it is clean and free of debris.
• Take an appropriate amount of glue from each of the two cans of Silicone Repair Glue, respectively. Stir them thoroughly in a 1:1 ratio until it becomes viscous. This can increase the curing speed of the glue.
• After mixing evenly, use a hair dryer to warm up the mixed glue. This can also increase the curing speed of the glue.
• Use appropriate tools or swabs to dip an appropriate amount of glue and apply it to the damaged area. Then carefully wipe off the residual glue on the surface.
  Let it stand for more than half an hour and then check whether the damaged part has been repaired properly.

Repair   Glue-TPE

• Clean  the  damaged  area  thoroughly.
• Apply glue  by  using tools or swab.
• Wipe  off  any  residual  glue  from  the  surface  carefuly.
• Let  it sit for  more than  half an  hour,then  check to  see  if the  damaged  part  has  been  repaired.

Nail   Glue-Silicone&TPE 

• Clean the nail area of the finger thoroughly.
• Remove the cap of the nail glue.
• Apply glue carefully.
• Stick on the nail, hold it in place gently for 30 seconds.
• Check to see if the nail has been stuck to the finger tightly.

Dye Remover

• Clean the dyed area with Cleansing Oil.
• Apply Dye Remover on the dyed area.
• Let it sit for 8 hours; most of the dye will be removed.
• Clean the skin with Cleansing Oil.

AB Gel

• Prepare an empty cup, a cup of Cleansing Oil, and the Syringe Bundle.
• Pinch the nipple with your fingers and insert the needle deep into the nipple.
  After insertion, use the needle to gently separate the gel section from the skin, creating a cavity to ensure a smooth injection process.
• Refer to step 2 and step 3 to create a cavity in the other breast.
• Connect the Syringe Needle with the Syringe Connector and make sure they are well connected.
• Using the cup, totally mix Gel A and Gel B in a ratio of 1:1.
• Fill the Syringe Barrel with gel and connect it to the Syringe Connector. Hold the joint in place to start the injection.
• Withdraw the needle and clean the Syringe with Cleansing Oil to prevent blockage.

Cleansing Oil

• Apply  on  the  stained  area  directly  then  wipe   it  clean,or soak  the  Cleaning  Cloth  with  Cleansing  Oil  then  wipe  it clean.